Guitar skins and wrap install

Many of our client use one of two ways to install.
Template install

1. Strip strings and pick ups off body.
2. clean face with rubbing alcohol
3. flip printed sheet on its back(print side down)
4. Lay body on top of sheet face side down.
5. trace body line on to skin backing paper
6. once you feel you have a good template cut out using the line you have drawn
7. peel off wrap backing and line up on face of guitar
8. use a credit card as a sweegie to work the air out of print and get it to lay flat
9. do a finial trim( if needed) on the outside of body) and cut out pick and knob holes
10. Reinstall hardware (i.e. strings and pick ups) and rock out with your new look.

Sheet install
1. Strip strings and pick ups off body.
 2. Clean face with rubbing alcohol
 3. Peel off wrap backing and line up on face of guitar
   4. Use a credit card to work the air out of print and get it to lay flat
   5. Trim the excess material from around body (being careful not to scratch body
   6. Do a finial trim (if needed) on the outside of body) and cut out pick and knob holes
7. Reinstall hardware (i.e. strings and pick ups) and rock out with your new look